How to configure a loopback interface in a Cisco Catalyst switch

How to configure a loopback interface in a Cisco Catalyst switch: A loopback interface is generally used by routers or Layer 3 capable switches so that they have a reliable IP interface for routing updates. In other words, a loopback interface is a special virtual interface created in software. It has no associated hardware interface and is therefore always up. One use of such an interface is to simply assign an IP address to the router as a whole rather than to a specific hardware interface. This allows the assigned IP address to be used to access the router, for example, Telnet, regardless of which real interfaces are up or down. Loopback interfaces are also used by some protocols. For example, the Loopback IP address can be used to assign the OSPF Router ID. There is no limit on the number of loopback interfaces you can create. Loopback interfaces do not have internal VLAN IDs or MAC addresses. With Layer 2 Cisco switches like the 3500XL or 2950, a loopback interface is not needed since these switches are not capable of routing between interfaces. The management VLAN of the switch acts like the loopback interface since they are both logical interfaces. When you have a Layer 3 switch like a Cisco Catalyst 3550 or 3750, to configure a loopback interface from the config mode, complete these steps:

Switch#configure terminal Switch(config)#interface loopback 1 Switch(config-if)#ip address Switch(config-if)#exit

Note: In order to remove the loopback interface, use the no interface loopback 1 in config mode. http://www.BradReese.Com

Join the Network World communities on Facebook and LinkedIn to comment on topics that are top of mind.
Must read: 10 new UI features coming to Windows 10