How to upgrade or replace power supply in Cisco Catalyst 6500 switch

How to upgrade or replace power supply in Cisco Catalyst 6500 switch:

Cisco Catalyst 6500/6000 series modules have different power requirements.

Certain switch configurations can require more power than a single power supply can provide, which depends on the wattage of the power supply.

Although the power management feature allows you to power all the installed modules with two power supplies, redundancy is not supported in this configuration.

With redundancy enabled, if you power up the system with two power supplies of unequal wattage, both power supplies come on line with a corresponding syslog message.

The message indicates that the lower-wattage power supply will be disabled.

If the active power supply fails, the lower-wattage power supply that was disabled comes on line.

If necessary, certain modules can be powered down in order to accommodate the lower-wattage power supply.

Power supplies in the Cisco Catalyst 6500 chassis are hot swappable and can be replaced without powering off the switch, as long as you have a redundant power supply.

For 6, 9, and 13-slot chassis, the minimum power supply requirement is a 2500 watt which can operate as a 1300W (110VAC) or as 2500W (220VAC, -48DC to -60DC).

For further Cisco Catalyst 6500 series power supply information refer to:

Power Supply Specifications

and

Effects of Power Supply Configuration Changes

View the inventory availability of Cisco Power Supplies.

View more Cisco How-To Tutorials.

http://www.BradReese.Com

	How to configure a Cisco Catalyst switch to act as a DHCP relay agent
	trixbox vs. Cisco: Enticing Cisco SMB channel partners to change their allegiance to trixbox
	Nortel vs. Cisco: The battle heats up
	He's back, Frank Quattrone the exonerated banker who brought Cisco public
	Invitation to Network World readers to attend ChicagoCon from the Ethical Hacker Network

• Cisco
• Data Center
• LANs / WANs