Skip Links

Network World

  • Social Web 
  • Email 
  • Close

(Comma separation for multiple addresses)
Your Message:

Botnet probe turns up 70G bytes of personal, financial data

The sensitive information collected by the Torpig/Sinowal botnet over just 10 days could be worth as much as $8.3 million
By Jeremy Kirk, IDG News Service
May 04, 2009 10:40 AM ET
  • Share/Email
  • Tweet This
  • Comment
  • Print

Researchers from the University of California gained control over a well-known and powerful network of hacked computers for 10 days, gaining insight into how it steals personal and financial data.

The botnet, known as Torpig or Sinowal, is one of the more sophisticated networks that uses hard-to-detect malicious software to infect computers and subsequently harvest data such as e-mail passwords and online banking credentials.

The researchers were able to monitor more than 180,000 hacked computers by exploiting a weakness within the command-and-control network used by the hackers to control the computers. It only worked for 10 days, however, until the hackers updated the command-and-control instructions, according to the researchers' 13-page paper.

Still, that was enough of a window to see the data-collecting power of Torpig/Sinowal. In that short time, about 70G bytes of data were collected from hacked computers.

The researchers stored the data and are working with law enforcement agencies such as the U.S. Federal Bureau of Investigation, ISPs and even the U.S. Department of Defense to notify victims. ISPs also have shut down some Web sites that were used to supply new commands to the hacked machines, they wrote.

Torpig/Sinowal can pilfer user names and passwords from e-mail clients such as Outlook, Thunderbird and Eudora while also collecting e-mail addresses in those programs for use by spammers. It can also collect passwords from Web browsers.

Torpig/Sinowal can infect a PC if a computer visits a malicious Web site that is designed to test whether the computer has unpatched software, a technique known as a drive-by download attack. If the computer is vulnerable, a low-level piece of malicious software called a rootkit is slipped deep into the system.

The researchers found out that Torpig/Sinowal ends up on a system after it is first infected by Mebroot, a rootkit that appeared around December 2007.

Mebroot infects a computer's Master Boot Record (MBR), the first code a computer looks for when booting the operating system after the BIOS runs. Mebroot is powerful since any data that leaves the computer can be intercepted.

Mebroot can also download other code to the computer.

Torpig/Sinowal is customized to grab data when a person visits certain online banking and other Web sites. It is coded to respond to more than 300 Web sites, with the top targeted ones being PayPal, Poste Italiane, Capital One, E-Trade and Chase bank, the paper said.

If a person goes to a banking Web site, a falsified form is delivered that appears to be part of the legitimate site, but asks for a range of data a bank would not normally request, such as a PIN (personal identification number) or a credit card number.

Web sites using SSL (Secure Sockets Layer) encryption are not safe if used by a PC with Torpig/Sinowal, since the malicious software will grab information before it is encrypted, the researchers wrote.

Hackers typically sell passwords and banking information on underground forums to other criminals, who try to covert the data into cash. While it's difficult to precisely estimate the value of the information collected over the 10 days, it could be worth between US$83,000 to $8.3 million, the research paper said.

  • Share/Email
  • Tweet This
  • Comment
  • Print

Partner Content

Gartner 2009 Magic Quadrant for Job Scheduling

Gartner has positioned BMC CONTROL-M in the Leaders Quadrant of their "2009 Magic Quadrant for Job Scheduling." The report assesses the ability to execute and completeness of vision of key vendors in the marketplace. Read a full copy today, courtesy of BMC Software.

Download whitepaper

Dell's SMART Approach to Workload Automation

Read a compelling case study by EMA, Inc. to learn how Dell uses BMC CONTROL-M to cut cost and increase productivity with workload automation.

Download whitepaper

Workload Automation Cost Savings 2 Minute Video

A major computer manufacturer uses BMC CONTROL-M and just four people to schedule and run over 85,000 jobs every month. By switching to BMC CONTROL-M, they more than quadrupled the workload without adding a single staff member.  See how in this 2-minute video overview.

Go to video

Comment
Login
Forgot your account info?
Add comment
Anonymous comments subject to approval. Register here for member benefits.
Have a NetworkWorld account? Log in here. Register now for a free account.

Videos

rssRss Feed