- 18 Hot IT Certifications for 2014
- CIOs Opting for IT Contractors Over Hiring Full-Time Staff
- 12 Best Free iOS 7 Holiday Shopping Apps
- For CMOs Big Data Can Lead to Big Profits
Network World - If at first you don’t succeed…
Alcatel-Lucent is set to give Cisco and Juniper another run for the money in core routing 10 years after its initial attempt failed.
The company this week is unveiling the 7950 Extensible Routing System (XRS), a platform for the core of the service provider IP network. The 7950 is optimized for the video and cloud era of networking, Alcatel-Lucent says, and represents 3-1/2 years of development.
The 7950 scales from 6.4Tbps to 32Tbps with a density of up to 160 100G Ethernet ports. Up to six nodes can be linked in a multichassis configuration of up to 240Tbps, the company says.
IT’S A JUNGLE OUT THERE: Six worst Internet routing attacks
The system is based on Alcatel-Lucent’s FP3 silicon, which supports up to 400Gbps per slot. The FP3 debuted a year ago with 100G Ethernet interfaces for the company’s edge routers.
The 7950 line includes three configurations. At the low end is the XRS-16c, which features 6.4Tbps of capacity, 16 interface slots, 32 100G Ethernet ports, 80 40G Ethernet ports, or 320 10G Ethernet ports in a single rack. This standalone system with be available in the first half of 2013.
In the mid-range is the XRS-20, which features 16Tbps of capacity, 20 interface slots, 80 100G, 200 40G, and 800 10G Ethernet ports in a single-rack. It can be configured as the XRS-40 by linking two chassis together, or it can be grouped in a mulltichassis configuration. It will ship in the third quarter and is in trials now.
At the high-end is the XRS-40. It features 32Tbps of capacity, 40 interface slots, 160 100G, 400 40G and 1,600 10G Ethernet ports in two racks. It will be available in the first half of 2013 and can be configured into a multichassis configuration.
Alcatel-Lucent says the 7950 represents a fivefold density increase over competing core routers, and a 66% reduction in power consumption. It says a single 7950 node is the equivalent of 10 or 12 competitors’ routers linked together in a multichassis configuration.
Alcatel-Lucent, however, did not disclose a timeframe for shipping its own multichassis interconnect. And separately, but nonetheless coincidentally, Juniper this week announced an increase in capacity on its own TXP multichassis system, from 6.4Tbps to 16Tbps. The TXP can link four Juniper T4000 or eight T1600 core routers into a high-capacity routing system, and Juniper plans to scale the TXP to 64Tbps at an undisclosed date.
The 16Tbps TXP will be available in the fourth quarter.
So competition is aggressive in core routing. Ten to 12 years ago, Alcatel – previous to its Lucent acquisition – debuted the 7770 Routing Core Platform and followed that on with ACEIS software for non-stop failover of key routing protocols like BGP, OSPF and IS-IS.
Alcatel hardly made a dent in the market; two years after the introduction of the 7770, the router was re-branded and repositioned as the 7770 Optical Branch Exchange before it was finally discontinued. ACEIS didn’t fare any better.
Why re-emerge after 10 years of the industry solidifying around Cisco and Juniper, and why now?