How we tested WideBand switch

How we benchmarked performance of the WideBand switch.

We benchmarked performance of the WideBand switch in four areas: throughput, latency, address learning and link aggregation.

For all tests, we used the Spirent TestCenter traffic-generation and -analysis tool and TestCenter's RFC 2889 software suite for switch testing.

In the throughput and latency tests, we offered traffic to all 28 ports in a bidirectional, fully meshed pattern, meaning we offered test traffic to all ports destined to all other ports. We measured throughput and latency for 60 and 300 seconds using a range of frame lengths from a minimum of 64 bytes to a maximum of 9,216 bytes.

In the address learning tests, we offered traffic to three pairs of ports at 1,000 frames per second, and used a seventh port to check for flooding.

In the link-aggregation test, we created an eight-port link-aggregation group on each of two switches and attached another 16 ports on each switch to the Spirent TestCenter instrument. Our intent was to offer test traffic in a bidirectional, partially meshed pattern, meaning all traffic offered to each port was destined for all edge ports on the other switch. However, a flow control issue with the WideBand switch's firmware prevented us from completing this test.


Return to main WideBand switch test

Learn more about this topic

Aruba wins wireless category with A2400 and A800 switches and A61 access point

02/27/06

Cisco wins network infrastructure award for Catalyst 4948-10GE

02/27/06

Join the Network World communities on Facebook and LinkedIn to comment on topics that are top of mind.
Now read: Getting grounded in IoT