Breakthrough could make it easier to lay fiber at long distances

Scientists say they've found a way to stretch fiber further without distortion, thus eliminating expensive repeaters.

comb lead image
U.C. San Diego

One of the big problems with fiber has always been that the more power you add to a signal—to get the signal to travel further—the more distortion you get. That distortion degrades the quality of the data.

It's a problem because ideally you want fiber to travel long distances. It's cheaper to run one long cable than multiple pieces with added repeaters, as is the current process now.

Deciphering data at 12,000 km

Scientists reckon they've got a solution, though.

Researchers at the University of California San Diego say they've been able to send data 12,000 kilometers along fiber without repeaters and still decipher the information at the end.

They did use standard amplifiers, however.

However, they say their experiment proves that you can eliminate the expensive regenerating repeaters. They accomplished this through distortion-reversing technology.

The photonics group published their findings in research journal Science.

Predictable crosstalk

It's a remarkably simple concept. The researchers reckon that the signal distortion, caused by crosstalk, is predictable. Therefore, it should be "reversible at the receiving end of the fiber," the university says in an article on its website.

Crosstalk is the interference that occurs between channels in the cable. The signal transmitted in one circuit creates an effect in another—it spills over. The researchers say that they know what the effect is, so they can cancel it out and thus eliminate the distortion.

Pre-distorted waveforms

The photonics group is using physics to achieve the results. Pre-distorted waveforms are printed on frequency-comb-originating carriers at the beginning. The uncorrupted information is then restored at the output of the optical fiber.

"We are pre-empting the distortion effects that will happen in the optical fiber," says Bill Kuo, a research scientist at the Qualcomm Institute. Kuo was responsible for the comb development and is an author on the group's Science paper.

Cancelling tech

Cancelling technology is becoming more prevalent in general. Some scientists are experimenting with algorithms to cancel self-interference in radios.

In that case, it's cheaper processing power, which for the first time allows more complicated mathematical calculations and formulae to be run. Algorithms are becoming more accessible.


Those radio-oriented scientists are working on self-interference cancellation in order to make better use of spectrum. The idea is that if you can second-guess how a transmission is affected by its own interference, you can cancel it and eliminate it.

Noise-canceling headphone technology has used this basic concept for years. The headphone listens to unwanted noise and mimics it out of phase, thus canceling it.

I've written about radio and interference canceling algorithms before in "Available spectrum could double with self-interference canceling algorithms."

Wideband comb

In the case of the fiber crosstalk elimination, a wideband frequency comb reverses the crosstalk in the same optical fiber.

"Today's fiber optic systems are a little like quicksand. With quicksand, the more you struggle, the faster you sink," says Nikola Alic, another research scientist from the Qualcomm Institute and an author on the group's Science paper.

With traditional "fiber optics, after a certain point, the more power you add to the signal, the more distortion you get, in effect preventing a longer reach," Alic says.

The new findings, if implemented, might solve that and could eliminate the need for the electronic regenerators, also known as repeaters, placed periodically along the fiber link. That's a major cost.

Join the Network World communities on Facebook and LinkedIn to comment on topics that are top of mind.

Copyright © 2015 IDG Communications, Inc.

SD-WAN buyers guide: Key questions to ask vendors (and yourself)